What Can You Get To Repair Gas Tank On A Tiller

One of the more of import components to any engine, is the gas tank. So it's no wonder that if the gas tank ever becomes damaged or broken, information technology will need to exist replaced as soon as possible. In this commodity, we'll guide you step-past-step through the process of replacing a gas tank in a Troy-Bilt Super Bronco tiller.

Looking for the gas tank used in this commodity? We've got it hither. Removing the Fuel Tank

1. Bleed the fuel out of the gas tank

Use a siphon pump to remove all of the gas from the fuel tank.

2. Remove the rear cover

Apply a screwdriver to remove the two screws on this cover, then set the cover bated.

3. Remove the two nuts on the side of engine

Use an open cease wrench to remove the ii nuts located beneath the tank on the side of the engine.

4. Remove the attachment screw

Use a socket wrench to remove the single attachment screw located almost the muffler.

5. Remove the fuel line

Use a pair of needle-olfactory organ pliers to pinch and slide the fuel clamp abroad from the grommet.

And then pry the hose away from the tank.

half-dozen. Remove the oil dip stick

Twist and remove this from the engine.

7. Remove the fuel tank

You can now pull the fuel tank off of the engine and set it bated.

8. Supplant the oil dip stick

With the fuel tank out of the way, replace the dip stick back into its original location.

ix. Remove the fuel cap, fuel lever indicator and fuel filter from the tank

The new fuel tank will need to be outfitted with a few of the parts from the old tank -- remove the fuel cap, fuel lever indicator and fuel filter from the old tank and set them aside.

[Back to Top]
Installing the New Fuel Tank

1. Install the fuel filter, fuel lever indicator and fuel cap to the new fuel tank

Screw the fuel filter into the new tank with a socket wrench, set the fuel lever indicator into the opening in the tank and screw the gas cap onto the new tank.

2. Remove the oil dip stick

Remove the dip stick again by unscrewing it and pulling it upwards and out of the engine.

3. Place the tank back onto the engine

Line it up into its original position.

4. Replace the oil dip stick

Reinstall the dip stick dorsum into the engine.

v. Reinstall and secure the fuel line

Utilise a pair of pliers or fuel line clamps to push button the fuel line back onto the grommet on the fuel tank.

Then slide the fuel line clamp back over the grommet to secure it.

6. Re-secure the tank attachment spiral

Replace and re-secure the attachment screw with a socket wrench.

7. Replace and tighten the nuts on the side of the engine

Supervene upon the two nuts on the side of the engine and re-secure them with a socket wrench.

8. Replace the rear encompass

Set the rear encompass back into information technology's original position and secure it with the two screws.

[Dorsum to Top]
Conclusion At this signal, your fuel tank should be fixed up and your tiller should be gear up to become. If you accept other repairs that need to be made on your your tiller or whatever other outdoor equipment, we recommend searching our Repair Centre for a guide. Otherwise, it'south time to start upwardly your tiller and become back to work! Shop for all of our Troy-Bilt tiller parts by browsing our parts pages. [Back to Height]
What We're About